Calls answered 24/7 · Nationwide plumbing help (888) 538-0664
Service area · Illinois

Plumbing Help in Chicago, IL

Chicago plumbing has a season. From the first hard freeze through the spring thaw, the calls shift from split pipes in unheated porches to basements filling from a surcharging sewer. In between, the city's greystones, brick two-flats, and bungalows keep their own older problems.

Neighborhoods and ZIP codes we hear from

Plumbing coverage follows the housing, not a map line. Calls tend to come from Bridgeport, Pilsen, and Beverly, plus the surrounding ZIP codes.

  • Bridgeport
  • Pilsen
  • Beverly
  • Avondale
  • Hyde Park
  • Andersonville

ZIP codes we commonly hear from include 60608, 60643, 60618, 60615, and 60640. If your neighborhood is not listed, call anyway; coverage depends on the day and the local professionals available.

The calls we hear most in Chicago

Local calls cluster around a few familiar problems. Here is what homeowners describe, and what tends to sit behind it.

Pipes that freeze and split

The first sustained cold snap exposes lines that survived milder winters. Pipes in rear porches, crawl spaces, and exterior walls freeze first, and a split often announces itself when the ice thaws. Open the cabinet doors, warm the pipe gently with a hair dryer, and leave the faucet open. Never use a torch indoors, and shut the main if water starts running from a split.

Basement backups during a thaw

Chicago's older neighborhoods drain stormwater and sewage through the same combined sewers. A fast melt or a heavy summer storm can fill those lines faster than they can carry, and the water has nowhere to go but the lowest drain in the house. A backwater valve helps, but recurring backups usually mean the lateral needs a look for roots, sag, or a collapsed section.

Questions about a lead service line

If your home went up before the mid-1980s, the pipe coming through the basement wall may be lead. Lead does not change the color, taste, or smell of water, so the reliable first step is identifying the pipe material where it enters the house or having the water tested. Replacement decisions belong to the homeowner and the utility, and the terms have changed over time.

Radiators and boilers that lose water

A hot-water or steam system that needs constant topping up is losing water somewhere, often at a valve, an air vent, or the circulator seal. Small leaks evaporate quietly and leave mineral crust instead of puddles. Look for white or rust-colored deposits at the boiler fittings and around the base of each radiator before the heating season starts.

Why plumbing in Chicago is a little different

Chicago drinks from Lake Michigan, treated at the city's purification plants and pushed through a grid that reaches well into the suburbs. The water is moderately hard, hard enough to leave scale on fixtures and inside water heaters but nowhere near the extremes of the desert Southwest. Scale collects on shower heads and on the elements of older tanks. The bigger local story is the pipe the water travels through. Many homes built before the mid-1980s still have a lead service line, and galvanized interior supply pipes in older buildings have had decades to narrow and rust from the inside.

The classic Chicago building types each hide plumbing differently. Greystones on the North Side have thick masonry walls, deep basements, and radiators fed from a boiler. Brick two-flats put one stack and one water heater to work for two households, with the basement holding the laundry and the floor drain. Bungalows on the Northwest and Southwest Sides were built with galvanized supply lines and low basements that sit close to the sewer. Courtyard buildings and six-flats add interior stacks that serve several units at once. Freeze risk concentrates in rear porches, unheated additions, and pipes along exterior walls.

Need help in Chicago?Tell us what is leaking, backing up, or not heating. We will check local availability.

(888) 538-0664

When to stop troubleshooting and call

You do not need to diagnose it over the phone. These signs mean stop and call:

  • Water is actively running and the fixture shutoff will not close.
  • Sewage is backing up into a tub, shower, or floor drain.
  • The water meter moves with every fixture turned off.
  • A water heater is leaking from the tank itself.
  • Water is near an electrical outlet, panel, or appliance.

If you smell gas, leave the building and call your gas utility or 911 first. A plumbing line is not the right first call for a gas leak.

One call that is not a plumbing call

If you smell gas, leave the building and call your gas utility or 911 from outside. Do not flip switches, light a match, or wait for a plumber to weigh in. The same goes for a carbon monoxide alarm that keeps sounding after you air the place out. A running toilet or a cold radiator can wait twenty minutes. A gas smell cannot.

Frequently asked questions — Chicago

How can I tell if my service line is lead?

Look at the pipe where it enters the basement or crawl space. Lead is dull gray and soft compared with steel, but paint and wrapping make a visual check unreliable. Have the material confirmed by the utility or a plumber, and use a water test to find out whether lead is reaching your tap.

Who is responsible for the service line?

Responsibility typically splits near the curb stop, with the city handling the connection at the main and the owner covering the run into the house. The details have shifted over the years and assistance programs come and go. Confirm the current terms for your address with the Department of Water Management before authorizing excavation.

What should I do if a pipe freezes?

Shut off the main if you can reach it, open the nearest faucet, and warm the pipe slowly with a hair dryer or warm towels, working from the faucet end back toward the freeze. Skip the open flame and the heat gun on high. If the pipe is already split, shut the water and call the plumbing line.

Why does my basement drain back up only when it rains?

That pattern points to the combined sewer surcharging rather than a clog in your own drain. The main is full, so water comes back up your line because it has nowhere else to go. A backwater valve can protect the basement, but have the lateral checked first for roots or a sag that makes the backup worse.

Talk to a Chicago plumbing professionalOne call, answered 24/7. No forms and no email tag.

(888) 538-0664

Chicago plumbing, one call away.

No forms. No quote emails. Describe the problem and we will check local coverage.

Plumbing trouble?Calls answered 24/7
(888) 538-0664